56K - FAQs
All files and documentation are offered on an *AS IS* basis and you assume full responsibility for using them.
Board Configuration 
The two resources that are set on the board itself are the IRQ and 
the I/O address. 

The IRQ is set by JP10.  
From the top of the card down, the available choices are: 
3, 4, 5, 7, 9, 10, 11, 12, and 15. 

The I/O address is set by the dip switch on the card.  
There are three switches.  
The position of these determines the I/O address: 

   Address Switch (3, 2, 1) 
   ------- ----------------
   370     On,  On,  On 
   3E0     On,  On,  Off
   3E8     On,  Off, On
   280     On,  Off, Off
   288     Off, On,  On
   290     Off, On,  Off
   298     Off, Off, On
   2E8     Off, Off, Off


_______________________________________________________________________________