MOUNTING A CANCUN TO A PINNACLE OR FIJI CARD:

1. Discharge any static electricity you might carry by touching a metal screw 
   in the chassis of your computer case.
2. Carefully remove from the motherboard your Pinnie/Fiji sound card
3. Find the pins on the Pinnie/Fiji labeled 'WaveTable' 
4. Carefully align the pins and insert them into the Cancun so that the body 
   of the Cancun is directly over the Pinnie/Fiji card
      NOTE: Alignment is of extreme inportance
5. Reinstall your Pinnie/Fiji into your computer
6. To use your Cancun, make sure the volume is up on your PC Mixer 
   for Daughter card  

------------------------------------------------------------------------------

USING THE CancunFX(tm) WITH THE PINNIE/FIJI:

  When using the CancunFX with a Pinnie/Fiji, you must set the daughterboard 
  type selection in the Advanced Options of the PC Mixer to either 
  "User Defined" or "Roland SCD-10/15".


------------------------------------------------------------------------------

SETTING UP PATCH NAMES FOR THE CANCUN:

  MIDI Orchestrator Plus(tm) can be setup so that the Cancun patch names are
  displayed in the track screen when the Cancun's MIDI port is selected for 
  that track. These patch names are displayed in the Track/View screen when
  the patch column is in the expanded mode or when you right-click in the 
  patch column. 

  To setup Cancun patch names for a Port:
  1. Choose the Patch Map Setup command from the Options Menu.
  2. Select the device driver for the Cancun.
  3. Enable the "Same" button to assign the patch names to all channels.
  4. Select the "Cancun" Patch Map for each channel.
  5. Disable the "Same" button.
  6. Click on channel 10 and select the "Cancun Drums" for this channel.
  7. Click Ok when you are done.


____________________________________________________________________________