The normal installation procedure outlined in the Help file will usually 
result in everything working.  However, if the MIDI Wavetable is not 
working, check the following: 

* In the computer's BIOS setup, set "PnP Aware OS" as DISABLED.  This is 
  crucial.  It is not set for a non-Plug and Play OS (which NT is), the 
  card won't function correctly.  Change the BIOS setting if incorrect 
  and then boot back into NT. 

* Make sure that a generic MPU-401 device is listed in the MIDI section of 
  the Control Panel | Multimedia | Devices tab.  If not, install one from 
  the NT CD.  Click the [Add] button and then select "MPU-401" from the 
  list that appears.  Insert the NT CD in the drive and click [OK].  A 
  configuration window should appear.  Select resource settings such as 
  port 330 and IRQ 9. 

* Make sure that "Low Level MIDI, Wave & Aux Support" appears in the MIDI 
  section of the Control Panel | Multimedia | Devices tab.  If not, click 
  [Add] in Multimedia | Devices, and select it from the list to install. 
  (The driver is on the NT CD.)

- Make sure that the control panel icon,  TBS Audio, used to control the 
  wavetable is set for 1 or 2 meg of system RAM for the samples.