Test the speakers by clicking each of the speaker icons in the SRM
Control Panel Speakers Tab. If you don't hear any sound, check the following:

- Check that the speakers are powered on and that the speakers are correctly
  connected to the SRM. Make sure you're not using passive speakers. The
  SRM can only drive powered speakers. If the speakers have a volume control
  or mute button, check that they are properly set.

- If the status light on the SRM is RED, the mute is active and the speakers
  will be silent. Turn off Mute by pressing the volume/mute control on the
  SRM.

- Check the SRM Control Panel Speakers Tab to see if the Master Volume
  slider is turned up.

- Check that the individual speaker volumes to the right of the Master Volume
  are turned up. Click the Reset button at the bottom of the volume section.

- Check the Mixer Tab to see if the Wave Volume slider is turned up and the
  Wave Volume Mute button is not turned on.

- In the Effects Tab, turn off the Speaker Position feature by clicking the
  Enable button so it's not lit blue.

- For Windows XP: Click Start > Control Panel > Sounds and Audio Devices >
  Audio and check that the Sound Playback and Sound Recording devices are 
  set to Turtle Beach Audio Advantage SRM Device. If the SRM does not appear
  in the list, the drivers may not have been installed properly from the CD. 
  Try uninstalling and reinstalling.
______________________________________________________________________________