* The manual states that the Maui has a 26-pin WaveBlaster connector which 
  connects to a second sound card (if installed). 

  CORRECTION: The current hardware version of Maui does not require any 
  internal connection between itself and any other card, so please disregard 
  any references to the 26-pin connector. 

* The "JP2 Port Settings" on page 12 show the same jumper settings for I/O 
  230 & 210.  

  CORRECTION: The setting for 230 is correct as shown and the setting for 
  210 should show ALL jumpers closed (or On). 

* Also, on the same page, 300 and 230 are switched as are 338 and 290.  

  CORRECTION: The correct settings are these: 300 has the top two jumper 
  blocks on, 230 has the bottom two, 338 has the top jumper block on and 290 
  has the bottom one.
 
* The manual mistakenly says to connect the ribbon cable from Maui's 26-pin 
  connector to the WaveBlaster header on a second soundcard (if installed).

  CORRECTION: The Maui does not utilize any General MIDI compatibility via 
  any direct connection between any other card.  Inserting the Maui into an 
  open ISA slot and installing the software will make everything functional.