Monte Carlo - FAQs
All files and documentation are offered on an *AS IS* basis and you assume full responsibility for using them.
Configuring a CD-ROM for use with the MonteCarlo 928 
-------------------------------------------------------------------------------
NOTE: This only applies if you have a CD-ROM connected directly to the
      Monte Carlo card.  If your CD-ROM is running from a separate controller 
      or the motherboard, this is not for you!
-------------------------------------------------------------------------------

1.  After the installation, re-enter Windows 95 and click on the start button.
2.  Select "Shutdown" and "Restart Computer in DOS Mode?".
3.  The computer will reboot now. When it is finished, you will be at a DOS
      prompt.
4.  At this point, run a DOS ONLY install from your original Monte Carlo
      install disk.
5.  Choose the appropriate CD-ROM from the list when prompted.
6.  Allow the install to complete normally from that point on.
6.  Using the DOS "Edit" progam, open the CONFIG.SYS file
7.  Move the MCMODE.EXE line to the top of the file.


____________________________________________________________________________