This error usually occurs during re-installation in earlier versions
(v1.0, 1.1, 1.2, 1.3) of the TBS-2000 drivers. 

1) Cancel the installation. 

2) Obtain the latest drivers version 1.5 ("2000_95.zip") from our web 
   (www.voyetra.com) or FTP (ftp.voyetra.com/pub) sites. 

3) Extract the file to a floppy disk or a folder on your hard drive. 

4) Locate the file "cleantbs.inf" on the installation diskettes. 
   Right-click on the file name and selecting Install.  This will 
   remove the previous unsuccessful installation. 

5) Reboot the system. 

6) After the sound card is detected, begin the installation process 
   again, using the 1.5 drivers.   

7) If you experience problems with the newer drivers:
   a) Download the EEPROM Update file ("2000_upd.zip") from our web 
      or FTP site. 
   b) Extract the file to a folder on the hard drive. 
   c) With the card in the system, boot into Real Mode DOS.  (Do not let
      Windows start, as it will re-detect the sound card and you will 
      have to repeat the process from step 4). 
   d) Change directories to the folder you extracted the EEPROM Update to. 
   e) Type UPDATE and hit [ENTER] to run the utility. 
   f) Follow the directions on screen
   g) At end it should report: Successful.  
   h) Run the install again (steps 4 - 6 above)
      
8) If after installing the new drivers, you receive the error message: 

     Error: "Protection Error" on restart (Win95)

   Remove the following line from your "config.sys" file: 

     DEVICE=C:\windows\TBS2000.EXE /w